Gigabyte GA-P67A-UD4 User Manual page 88

C. Configuring a RAID array
Create a RAID Array:
Move the selection bar to HBA 0: Marvell 0 and press <Enter>.
Topology
HBA 0 : Marvell 0
Virtual Disks
Free Physical Disks
PD 0: WDC WD800JD-22L
PD 8: WDC WD800JD-22L
Help
Marvell RAID on chip controller.
ENTER: Operation F10: Exit/Save ESC: Return
Under Free Physical Disks, use the <Space> key to select the hard drives to be included in the RAID array.
The selected hard drive will be marked with an asterisk (*). After selecting the hard drives, press <Enter> to
proceed (Figure 3).
Topology
HBA 0 : Marvell 0
Virtual Disks
Free Physical Disks
* PD 0: WDC WD800JD-22L
* PD 8: WDC WD800JD-22L
Help
Use space bar to select the free disks to be used in the array.
ENTER: Operation SPACE: Select F10: Exit/Save ESC: Return
Appendix
Marvell BIOS Setup (c) 2009 Marvell Technology Group Ltd.
Information
Vendor ID
Device ID
Revision ID
BIOS Version
Firmware Version
PCIe Speed rate
Configure SATA as :
Figure 2
Marvell BIOS Setup (c) 2009 Marvell Technology Group Ltd.
Information
Port ID
PD ID
Type ID
Status
Size
Feature Support
Current Speed
Model
Serial
FW version
Figure 3
: 1B4B
: 91A3
: B1
: 0.0.0.0000
: 2.1.0.1502
: 5.0Gbps
IDE Mode
: 0
: 0
: SATA PD
: Unconfigured
: 114472MB
: 1.5G 48Bit
: 1.5G Mode
: WDC WD800JD-22LS
: WD-WMAM9W736333
: 3.18
- 88 -