Gigabyte GA-P67A-UD4 User Manual page 25

7) SATA3_0/1 (SATA 6Gb/s Connectors, Controlled by P67 Chipset)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The SATA3_0 and SATA3_1
connectors support RAID 0 and RAID 1. RAID 5 and RAID 10 can be implemented on the two connec-
tors with the SATA2_2/3/4/5 connector
instructions on configuring a RAID array.
8) SATA2_2/3/4/5 (SATA 3Gb/s Connectors, Controlled by P67 Chipset)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s stan-
dard. Each SATA connector supports a single SATA device. The P67 controller supports RAID 0,
RAID 1, RAID 5, and RAID 10. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on
configuring a RAID array.
• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard
drives are to be used, the total number of hard drives must be an even number.
• A RAID 5 configuration requires at least three hard drives. (The total number of hard drives
does not have to be an even number.)
• A RAID 10 configuration requires four hard drives.
(Note) When a RAID set is built across the SATA 6Gb/s and SATA 3Gb/s channels, the system
performance of the RAID set may vary depending on the devices being connected.
. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for
(Note)
SATA3_1
7
7
SATA3_0
SATA2_5
7
7
SATA2_4
- 25 -
Pin No. Definition
1
2
3
1
4
1
5
6
7
Pin No. Definition
1
2
SATA2_3
3
1
4
1
5
SATA2_2
6
7
Please connect the L-shaped end of
the SATA cable to your SATA hard
drive.
Hardware Installation
GND
TXP
TXN
GND
RXN
RXP
GND
GND
TXP
TXN
GND
RXN
RXP
GND