Table of Contents
Advertisement
UnixWare Installation
To Configure the Ethernet Interface
To Configure the
Ethernet Interface
Introduction
You configure the Ethernet interface for the Proxy Agent when you
set the ifconfig options in the UNIX system.
When to use
Configure the Ethernet interface after you set the system name for
the Proxy Agent PC.
Materials
You need the following information to configure the Ethernet
needed
interface:
UNIX
Use the following steps to configure the Ethernet interface.
commands
The IP address for the Proxy Agent PC.
The system name as it appears on the PA001 form.
Your network's configuration, including the netmask for your
local network. (See your network administrator if you need
help.)
Command
Description
ifconfig
Assigns an address to a network interface and
configures the interface's parameters.
netmask
Determines which part of your network address
is used as a network ID and which part is used
as the Proxy Agent ID.
Issue 2 April 1996
3-13
Advertisement
Table of Contents
