Programming Features - AT&T MERLIN PIus Attendant Installer's Manual

Programming Features

COMPLETING THE
PLANNING
CONFIGURATOR
FORM
ENTERING
PROGRAMMING
MODE
The MERLIN Attendant is programmed from a Touch-
Tone phone using special command strings that are
discussed in this section. For each command string:
*
tells the MERLIN Attendant that the following
digits are a part of a command string. It can also be
used to start a command over when a mistake is made
## denotes the end of an entry or executes the
command string
CAUTION: All on-site programming for the
MERLIN Attendant must be done from a multi-line
MERLIN phone that is connected to the MERLIN Plus
system control unit. To program from a remote
location, use a standard single-line Touch-Tone phone
and enter one pound sign (#) for every two pound signs
(##) that appear in a programming command.
Ask the customer for the completed MERLIN Attendant
Planning Configurator Form. If this form has not been
completed, assist the customer in completing it before
proceeding.
Perform the following steps before you begin
programming:
1
Select an outside line and dial a telephone number that
is answered by the MERLIN Attendant. Wait for the
tone.
Single beep sounds to indicate there are no announcements
recorded.
2 Dial the default authorized caller code: *789##
The two-beep confirmation tone sounds.
3 Dial *990046## (the MERLIN Plus system macro
code) to initialize the system for MERLIN Plus system
operation.
Programming Features 2 - 1