Checking Jumper Settings; Jumper Settings - ECS G41T-M2 Manual

Checking Jumper Settings

The following illustration shows the location of the motherboard jumpers. Pin 1 is
labeled.

Jumper Settings

Jumper Type
Description
CLR_CMOS 3-pin Clear CMOS
Front Panel
USBPWR_F 3-pin
USB Power
Select Jumper
Rear USB PS/2
USBPWR_R 3-pin
Power Select
Jumper
1. To avoid the system instability after clearing CMOS, we recommend
users to enter the main BIOS setting page to "Load Default Settings"
and then "Save and Exit Setup".
2. Make sure the power supply provides enough 5VSB voltage before
selecting the 5VSB function.
3. It is required that users place the USBPWR_F & USBPWR_R cap onto
2-3 pin rather than 1-2 pin as default if you want to wake up the com-
puter by USB/PS2 KB/Mouse.
Installing the Motherboard
Setting (default)
1-2: NORMAL
2-3: CLEAR
1
Before clearing the
CMOS, make sure to
CLR_CMOS
turn off the system.
1-2: VCC
1
2-3: 5VSB
USBPWR_F
1-2: VCC
2-3: 5VSB
USBPWR_R
9
1