Clutch Hydraulic System; Clutch Linkage; Rear Axle And 4X4 Front Driving Axle Fluid Level - Dodge Ram Gas Owner's Manual

374 MAINTAINING YOUR VEHICLE
Brake Hoses
Inspection should be performed whenever the brake
system is serviced or at intervals specified. Inspect hy-
draulic brake hoses for surface cracking, scuffing or worn
spots. If there is any evidence of cracking, scuffing, or
worn spots, the hose should be replaced immediately!
Eventual deterioration of the hose can take place with
possible burst failure.

Clutch Hydraulic System

The clutch hydraulic system is a sealed maintenance-free
system. In the event of leakage or other malfunction, the
system must be replaced.

Clutch Linkage

If the clutch pedal linkage begins to squeak or grunt, the
clutch pedal pivot bushings should be lubricated. Refer
to Recommended Fluids, Lubricants and Genuine Parts
for the correct lubricant type.

Rear Axle And 4x4 Front Driving Axle Fluid Level

Refer to Recommended Fluids, Lubricants and Genuine
Parts for the correct Fluid type. For normal service,
periodic fluid level checks are not required. When the
vehicle is serviced for other reasons the exterior surfaces
of the axle assembly should be inspected. If gear oil
leakage is suspected inspect the fluid level.
This inspection should be made with the vehicle in a level
position. The fluid level should be even with the bottom
of the fill hole for the Manufacturer's C205F HD Front
Axles. The fluid level should be 5/8" (16 mm) below on
9 1/4" Manufacturer's Rear Axles.
For all 2500/3500 Model axles, the fluid level should be
1/4" ± 1/4" (6.4 mm ± 6.4 mm) below the fill hole on the
9.25" Front and 3/4"± 1/4" (19 mm ± 6.4 mm) on 10.5"
Rear axles. The 11.5" Rear Axle level should be 1/4" ±
1/4" (6.4 mm ± 6.4 mm) below the fill hole.