Sound System; Pointing Device - Toshiba PSPB0U-00W008 User Manual

Problem
Monitor goes into
panning mode

Sound system

Problem
No sound is heard

Pointing device

If you are using a USB mouse, also refer to the
and to your mouse documentation.
TouchPad/Dual Mode Pad
Problem
On-screen pointer does
not respond to Pad
operation
Double-tapping does
not work
User's Manual
Procedure
Check your monitor specification. It might not
support the selected resolution and refresh rate.
The resolution on the monitor might go into
panning mode when wide screen resolution is
selected. Refer to Appendix B,
Procedure
Adjust the volume control dial.
Check the software volume settings.
If appropriate, make sure the headphone
connection is secure. Check Windows Device
Manager and ensure the sound function is
enabled and that settings for I/O address,
interrupt level and DMA are correct for your
software and do not conflict with other hardware
devices that you have connected to the
computer.
If problems persist, contact your dealer.
Procedure
The system might be busy. If the pointer is
shaped as an hourglass, wait for it to resume its
normal shape and try again to move it. You may
also press Fn + F9 to enable the TouchPad/Dual
Mode Pad and then try again to move it.
Try changing the double-click speed setting in the
mouse control utility.
1. Open the Control Panel, select the Mouse
icon and press Enter.
2. Click the Buttons tab.
3. Set the double-click speed as instructed and
click OK.
Troubleshooting
Display Modes.
USB section in this chapter
9-9