Brother BE-438D Instruction Manual page 53

5
To record another cycle program, repeat steps 2 to 4.
6
End cycle program recording mode.
<Using a cycle program>
• If you press the or
need to carry out home position detection again.)
• If you press the SELECT key (5), you can check the details (such as X-scale, Y-scale and sewing speed) of the user
program for the displayed step. The setting cannot be changed at this time.
Note:
If cycle program sewing mode is active (when memory switch no. 401 is "ON") but no cycle programs have been
recorded, the user programs will be sewn in numeric order.
"C-0" will appear in the PROGRAM No. display at this time.
TEST indicator switches off
Menu indicators light
key (4), you can return to the previous step or skip to the next step respectively. (You do not
6. USING THE OPERATION PANEL (ADVANCED OPERATIONS)
Press the TEST key.
This completes the recording of cycle programs.
• The cycle program number will flash in the PROGRAM
No. display, and the sewing machine will switch to
home position detection standby.
1. Press the
number that you would like to use.
• If the cycle program number is flashing, depress the
foot switch to move the feed mechanism to the home
position. After this, it is not necessary to detect the
home position until the next time the power is turned
off and back on, even if you change the cycle program
number.
• The cycle program number can be selected directly
by pressing function keys F1 to F4 (2). (Refer to "6-8.
Direct selection".)
2. Check that the needle drop position is correct, and then
start sewing. (Refer to "5-5./5-6 Checking the sewing
pattern".)
3. The recorded user program will be sewn step by step,
and when the final step is complete, the menu display
(3) will return to showing step 1.
4442Q
KE-430D, BE-438D
or key (1) to select the cycle program
4439Q
46