Table of Contents
Advertisement
This function allows you to invert the tilt movement. Use the [ + ] and [ - ] keys to select "On" if you wish this
feature or "Off" if you don't wish this feature and press [ Menu ] to confirm and return to the main menu.
This function allows you to run a special test program without an external controller, which show you some
possibilities of using ULTRA SCAN. Press the [ Menu ] key to run the test program, the "tSt" will start to flash.
Press [Enter] key to run reset. This option enables the ULTRA SCAN to index all effects (functions) and return to
their standard positions.
8.1 Special functions - calibration
Run a test program, "tSt" must flashing. Press [ + ] and [ - ] keys together and hold them until the display will
show message "C08" meaning the calibration value of the colour wheel. Use [ + ] and [ - ] keys to adjust a new
calibration value from range "C00 - C15", the wheel moves in microsteps, so you can easilly center current
colour.
Press [ Menu ], on the display will appear message "G08", meaning the calibration value of the gobo wheel.
Use [ + ] and [ - ] keys to adjust a new calibration value from range "G00 - G15", the wheel also moves in
microsteps, so you can easilly center current gobo. Now press [Menu ] in order to go back to colour calibration
(display shows current colour calibration value) or press and hold [ Menu ] key until the display will show "tSt" in
order to finish calibration procedure.
9.Technical specifications
Power supply:
-Voltage......................100/115/208/230 V AC, 50/60 Hz ~
-Fuse..........................T 6,3 A@ 115V
-Power consumption.....500VA
Lamp:
-MSD/HSD 250,MSD 250/2 , GY-9.5
Optical System:
- High reflecting aluminium-coated parabolic reflector
- Manual focus
- Standard 19° focused beam angle
Bampath:
Tilt reverse
Test program
Reset Function
12
Advertisement
Table of Contents
