Advertisement
Aggressor™
Caution:
Always replace with the exact same type lamp, unless oth-
erwise specified by an authorized American DJ
with anything other than the specified part can damage your unit and
will void your manufactures warranty.
Warning:
If after you have replaced the lamp and you continue
to blow lamps, STOP using the unit. Contact customer support for
further instructions, you may have to return the unit for servicing.
Continuing to use the unit may cause serious damage.
Lamp Replacement: Caution! Never open the unit while in use.
1. Be sure to follow the proper procedures included with your new
lamp when handling halogen lamps. Never touch the new lamp
with your bare fingers.
2. Lamp replacement has been made simple by incorporating the
use of a flip-up lamp cover retained by flip-up latches.
3. Unlock the latches on the top of the unit that hold the lamp cover
in place.
4. Flip up the lamp cover to expose the lamp/socket assembly.
5. Remove and replace the bad lamp(s).
6. Reassemble in reverse order.
For any other service related issues, please contact American DJ
tomer support.
Aggressor™
Reset Breaker:
This unit uses a protective breaker to protect the unit in the event of
power surges or fluctuations. To reset the breaker, push the breaker
button in until you hear it pop back in to place. If the breaker continues
to pop, stop using the unit and contact customer support the unit may
require service.
Aggressor™
The Aggressor™ carries a one year (365 days) limited warranty. We
recommend you fill out the enclosed warranty card to validate your
purchase. All returned service items whether under warranty or not,
must be freight pre-paid and accompany a return authorization (R.A.)
number.
American DJ Supply
- www.americandj.com - Aggressor™ Instruction Manual Page 5
©
®
Lamp Replacement
technician. Replace
®
cus-
®
Breaker
Warranty Registration
Aggressor™
Due to fog residue, smoke, and dust, cleaning the internal and external
optical lenses must be carried out periodically to optimize light output.
1. Use normal glass cleaner and a soft cloth to wipe down the outside
casing.
2. Use a brush to wipe down the fan grill and air vents.
3. Clean the external optics with glass cleaner and a soft cloth every
20 days. Situation may very. If used heavily in clubs with lots of
fog, cleaning may be required more often.
4. Clean the internal optics with glass cleaner and a soft cloth every
30-60 days.
5. Always be sure to dry all parts completely before plugging the
unit in.
Cleaning frequency depends on the environment in which the
fixture operates (i.e. smoke, fog residue, dust, dew). Proper
cleaning may extend the life of your unit drastically
Aggressor™
Trouble Shooting: Listed below are a few common problems and
solutions you should try before contacting customer support.
No light output from the unit;
1. Occasionally lamps become loose during shipping, open the lamp
cover and be sure the lamps are seated in the socket properly.
2. Be sure you have connected your unit into a matching power
outlet.
3. Be sure the external fuse has not blown. The fuse is located on
the rear panel.
Unit does not react to sound;
1. Low frequencies (bass) should cause the unit to react to sound.
Tapping on the microphone, quiet or high pitched sounds may not
activate the unit.
Aggressor™
The 220v version of the Aggressor™ uses lamps wired in series.
Because the lamps are wired in a series confi guration, when one lamp
goes bad the other will not function. This may not mean both lamps
have gone bad. Please check each lamp carefully when replacing
lamps. Be sure not to touch the lamps with your fi ngers.
American DJ Supply
- www.americandj.com - Aggressor™ Instruction Manual Page 6
©
®
Cleaning
Trouble Shooting
220 Volt Lamp Notice
Hide quick links:
Advertisement
