Screen Position Adjustment; Connecting The Power Cord; Power Saving - Acer F-22 User Manual

Screen position adjustment

To optimize the viewing position, you can adjust the
monitor tilt, using both of your hands to hold the
edges of the monitor. The monitor can be adjusted to
15 degrees up or 5 degrees down.

Connecting the power cord

•
Check first to make sure that the power cord you
use is the correct type required for your area.
•
The monitor has a universal power supply that
allows operation in either 100/120 V AC or 220/
240 V AC voltage area. No user-adjustment is
required.
•
Plug one end of the power cord to the AC inlet, and plug the other end
into an AC outlet.
•
For units using 120 V AC:
Use a UL-listed cord set, type SVT wire and plug rated 10 A/125 V.
•
For units using 220/240 V AC:
Use a cord set consisting of H05VV-F cord and plug rated 10 A/250 V. The
cord set should have the appropriate safety approvals for the country in
which the equipment will be installed.

Power saving

The monitor will be switched to "power
saving" mode by the control signal from
the display controller, as indicated by
the pulsating red power button/
indicator.
The power saving mode will be kept until a control signal has been detected or
the keyboard or mouse is activated.
The recovery time from "power saving" mode back to "on" is around 3 seconds.
Mode LED light
On Red
Power saving Pulsating red
3
5°
15°