Candy Aquamatic 10 T User Instructions page 6

Fix the sheet of corrugated material on the
bottom as shown in picture.
WATER CONNECTION
Your machine may either be plumbed in or
connected to existing taps, using a tap
adaptor with a 3/4 B.S.P . threaded end
connection. The water supply hoses can be
found inside the drum and are terminated in
two different ways. One end which has a 90°
elbow is to be connected to the appliance
water connection E while the straight end is
to be connected to the domestic supply
tap. The hose with the white collar should be
connected to the cold tap, and the hose
with the red collar to the hot tap. The
appliance is not suitable for use with mixer
taps.
The appliance must be connected to the
water mains using new hose-sets. The old
hose-sets should not be reused.
Hook the end of the outlet hose over the rim
of the sink or outlet pipe, making sure that it
is not kinked. For better positioning of the
outlet hose make use of the plastic hose
clamp provided.
Where possible, use a fixed discharge pipe
with a diameter greater than that of the
outlet hose of the washing machine to allow
air to escape.
The minimum height of the top of the outlet
hose should be 50 cm.
Extending the outlet hose, especially if the
extension is more than 1 metre, could lead
to malfunctioning of the discharge.
10
UK
E
COLD
WATER
HOT
WATER
=
50 cm.
The programme chart is located inside of the
detergent drawer as indicate.
Level the machine by means of the front foot.
a) Turn the nut clockwise to release the screw
adjuster of the foot.
b) Rotate the foot to raise or lower until it
stands firmly on the ground.
c) Lock the foot in position by turning the nut
anti-clockwise until it comes up against the
bottom of the machine.
ELECTRICAL CONNECTIONS
If the plug we supply does not fit
CUT IT OFF AND DESTROY IT!
You can't use it on other appliances, and the
exposed wires could be dangerous if anyone
plugged it in.
Fit a suitable plug, as follows:
Connect
green and yellow
wire
blue wire
NO
brown wire
NO
WARNING
This appliance must be earthed
After installation, the appliance must be
positioned so that the plug is accessible.
Fuses and plugs
This appliance should be used only on a socket
with a minimum rating of 13 Amps.
Our ready-fitted plug is already equipped with
a 13 amp fuse which is BS 1362 ASTA approved.
Any replacement should be exactly the same.
If the fuse cover is lost, do not use the plug until
it is replaced. A correct replacement fuse
cover (obtainable from your dealer or
Electricity Board) must be the same colour as
shown or named on the insert on the base of
the plug.
UK
to the terminal in the plug
marked withe the letter E, OR
marked with the
.............
symbol,
OR coloured green,
OR coloured green and yellow.
marked N
OR coloured black.
marked L
OR coloured red.
7
8
A
B
C
11