Preparation Of Top Cabinet; Adjust Blower - Electrolux Over The Range Microwave Oven Installation Instructions Manual

B2.
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws, a
hole large enough for the power cord to fit through,
and a cutout large enough for the exhaust adaptor.
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom.
Installation Instructions
B3.
1.
Remove and save
screw that holds
blower plate to
microwave.
Blower Plate
3.
Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the
blower unit.
CAUTION: Do not touch blade of blower to prevent
cracking and breaking. Hold outer case when the
blower is removed and re-installed.
4.
Roll the blower unit 90° so that fan blade
openings are facing toward the top of the
microwave.
BEFORE: Fan Blade
Openings Facing Forward
15
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE TOP
EXHAUST
Screw
Roll
2.
Lift up the
blower plate.
Back of
Microwave