Actron OBD II AutoScanner CP9135 Instructions Manual page 5

Performs diagnostics on obd ii compliant vehicles 1994 and newer
Table of Contents

Advertisement

Always use caution when working around the ignition coil,
distributor cap, ignition wires, and spark plugs. These
components can produce High Voltage while the engine
is running.
Battery electrolyte is sulfuric-acid and is extremely caustic.
If contacted, rinse with water or neutralize with a mild base
(i.e. baking soda). If contacted in eyes, flush with water
and call a physician immediately.
Never smoke or have open flames near vehicle. Vapors
from gasoline and the battery during charge are highly
flammable and explosive.
Never use the AutoScanner
exposed to any moisture. Internal shorts could cause fire
and damage to the tool.
Always keep a fire extinguisher suitable for
gasoline/electrical/chemical fires readily available.
• When performing road tests, never operate the tool while driving
the vehicle. Always have one person drive the vehicle and an
assistant operate the AutoScanner
• Always turn ignition key OFF when connecting or disconnecting
electrical components, unless otherwise instructed.
• Some vehicles are equipped with safety air bags. You MUST follow
vehicle service manual cautions when working around the air bag
components or wiring. If the cautions are not followed, the air bag
may open up unexpectedly, resulting in personal injury. Note that
the air bag can still open up several minutes after the ignition key is
off (or even if the vehicle's battery is disconnected) because of a
special energy reserve module.
• Always follow vehicle manufacturer's warnings, cautions and
service procedures.
TM
if internal circuitry has been
TM
.
SF-2

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents