These operations are accessible by remote control.
Some may also be accessible by control panel on the main unit.
First time setup
This section will guide you for the language selention of your on-screen
menu and auto tuning, which automatically scans and memorizes
viewable channels.
1
Make sure the unit is connected to antenna or cable.
2
After making all the necessary connections, press
unit.
• It may take a few moments to Turn On the unit for the first time.
Language selection
You can select the preferred on screen language.
1
Press
and use ◄► to select
OPTION
Move
Menu
2
Use ▲▼ to select OSD Language, then press OK.
3
Use ▲▼◄► to select the language you want, then press OK.
Note
• Available options are: Español / English.
to Turn On the
(OPTION).
OSD Language
English
Aspect Ratio
16:9
Blue Screen
Off
Key Lock
Off
Reset
Software Update(USB)
Enter
Exit
Auto Tuning
Be sure the RF cable is correctly connected to this unit and you are
registered with your cable TV provider when you install Cable channels.
1
Press
and use ◄► to select
CHANNEL
Move
Menu
2
Use ▲▼ to select Auto Tuning and then press OK to start
scaning.
Note
• When the scanning and memorizing channels are completed, the lowest memorized
channel will be displayed.
• After setting Auto Tuning, using CH + / − skips unavailable programs automatically.
• If you are not receiving a signal from your cable service, contact the Cable provider.
during Auto Tuning, the setup of TV channels will be cancelled.
• If you press
or
• Even if Auto Tuning is completed, the channel setting will be lost if the AC power cord
is unplugged before the unit goes into Standby mode by pressing
(CHANNEL).
Tune Type
Auto Tuning
ATV Manual Tuning
Program Edit
Enter
Exit
.
15
English