Connecting The Antenna Or The Cable; Connecting A Set-Top Box, Blu-Ray Disc / Dvd Recorder Via Composite Connectors And Analog Audio; Plugging In The Ac Power Cord - Philips 29PFL4508/F4 User Manual

Connecting the antenna or the cable

Be sure your antenna or other device is connected properly before

plugging in the AC power cord.

If you connect to an antenna through RF cable
Any DTV programs that are broadcasted in your area can be received
for free through an antenna connection.
antenna
IN IN IN
If you connect a set-top box through RF cable
If the TV is connected to a cable / satellite set-top box via a coaxial
connection, set the TV to channel 3, 4 or the channel specified by the
service provider.
antenna
RF cable
IN IN IN
If you connect a set-top box through HDMI
If the TV is connected to a cable / satellite set-top box via HDMI, make
sure you select the correct Source by using
HDMI cable
IN IN IN
If you connect a set-top box through Component Video Input
If the TV is connected to a cable / satellite set-top box via Component
Video Input, make sure you select the correct Component Video Source
SOURCE.
by using
IN IN IN
IN IN IN
Audio (L/R) cables
Component (Y/Pb/Pr)
video cables
cable
OUT
RF cable
RF cable
IN
OUT
set-top box
SOURCE.
RF cable
IN
OUT
set-top box
RF cable
OUT OUT OUT
IN
set-top box
OUT OUT OUT
Connecting a set-top box, Blu-ray disc / DVD recorder
via composite connectors and Analog Audio
Do not place your recorder too close to the screen because some
recorders can be susceptible to signals.
RF cable
RF cable
IN IN IN
Audio (L/R) + Video cables
IN IN IN
Note
• If you have any question about the DTV's antenna, visit www.antennaweb.org for
further information.
• Depending on your antenna system, you may need different types of combiners
(mixers) or separators (splitters) for HDTV signal. The minimum RF bandpass on
these devices is 2,000MHz or 2GHz.
• For your safety and to avoid damage to this unit, please unplug the RF coaxial cable
from the antenna Input jack before moving the unit.
• If you did use an antenna to receive Analog TV, it should also work for DTV reception.
Outdoor or attic antennas will be more effective than a set-top box or inside antenna.
• To Turn On your reception source easily between antenna and cable, install an
antenna selector.
• If you are not receiving a signal from your cable service, contact the Cable provider.
• Only the left loudspeaker reproduces sound for mono equipment. Use a mono to
stereo adapter (not supplied) for sound reproduction via all internal loudspeakers.
Plugging in the AC power cord
Make sure that the AC power cord must be plugged to an AC outlet
after all the necessary connections are made.
Caution
• Do not connect the AC power cord to a power supply outside the indicated voltage
of this unit (AC 120V).
• Connecting the AC power cord to a power supply outside of this range may result in
fire, smoke, unit failure or electrical shock.
Note
• Each time you plug in the AC power cord, no operations will be performed for a few
seconds. This is not a malfunction.
cable
OUT OUT OUT
set-top box
IN
OUT
OUT
Audio (L/R) +
Video cables
IN
OUT OUT OUT
Blu-ray disc / DVD recorder
11
English