Storage Configuration - Asus P5Q WS User Manual

DMA Mode [Auto]
Selects the DMA mode.
Configuration options: [Auto] [SWDMA0] [SWDMA1] [SWDMA2] [MWDMA0]
[MWDMA1] [MWDMA2] [UDMA0] [UDMA1] [UDMA2] [UDMA3] [UDMA4] [UDMA5]
SMART Monitoring [Auto]
Sets the Smart Monitoring, Analysis, and Reporting Technology.
Configuration options: [Auto] [Disabled] [Enabled]
32Bit Data Transfer [Enabled]
Enables or disables 32-bit data transfer.
Configuration options: [Disabled] [Enabled]
3.3.6

Storage Configuration

The items in this menu allow you to set or change the configurations for the SATA
devices installed in the system. Select an item then press <Enter> if you want to
configure the item.
Main
Storage Configuration
SATA#1 Configuraton
Configure SATA#1 as
Hard Disk Write Protect
IDE Detect Time Out (Sec)
SATA#1 Configuration [Enhanced]
Configuration options: [Disabled] [Compatible] [Enhanced]
Configure SATA#1 as [IDE]
Sets the configuration for the Serial ATA connectors supported by the
Southbridge chip. Configuration options: [IDE] [RAID] [AHCI]
•
•
•
3-14
BIOS SETUP UTILITY
[Enhanced]
[IDE]
[Disabled]
[35]
If you want to use the Serial ATA hard disk drives as Parallel ATA physical
storage devices, keep the default setting [IDE].
If you want the Serial ATA hard disk drives to use the Advanced Host
Controller Interface (AHCI), set this item to [AHCI]. The AHCI allows
the onboard storage driver to enable advanced Serial ATA features that
increases storage performance on random workloads by allowing the drive
to internally optimize the order of commands.
If you want to create a RAID 0, RAID 1, RAID 5, RAID 10, or the Intel
Matrix Storage Technology configuration from the Serial ATA hard disk
drives, set this item to [RAID].
Options
Disabled
Compatible
Enhanced
®
Chapter 3: BIOS setup