Marvell ® Raid Configurations - Asus P5Q WS User Manual

4.4.4 Marvell
The Marvell ® 6121 Serial ATA controller allows you to configure RAID 0 and RAID 1
sets on the Serial ATA hard disk drives.
Setting the RAID item in BIOS
You must set the RAID item in the BIOS Setup before you can create a RAID
set(s). To do this:
1. Install two Serial ATA hard disk drives to the eSATA connectors on the rear
panel.
2. Boot up your computer, and press <Del> during POST to enter the BIOS
setup.
In the Advanced Menu, go to Onboard Devices Configuration, and set
3.
Marvell IDE/eSATA to [RAID Mode].
Advanced
Onboard Devices Configuration
High Definition Audio
Front Panel Type
SPDIF OUT Mode Setting
Realtek Gigabit LAN
LAN Boot ROM
Realtek Gigabit LAN2
Agere Firewire 1394
Marvell IDE/eSATA
IDE/eSATA Boot ROM
Serial Port1 Address
v02.61 (C)Copyright 1985-2008, American Megatrends, Inc.
3. Press <F10> to save the changes and exit.
The RAID BIOS setup screens shown in this section are for reference only, and
may not exactly match the items on your screen.
ASUS P5Q WS
RAID configurations
®
BIOS SETUP UTILITY
[Enabled]
[HD Audio]
[SPDIF]
[Enabled]
[Disabled]
[Enabled]
[Enabled]
[RAID Mode]
[Enabled]
[3F8/IRQ4]
Enable or Disable
High Definition Audio
Controller
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
4-49