Table of Contents
Advertisement
5.4.4
Marvell
®
The Marvell
and RAID 10 set(s) on the SAS hard disk drives.
Setting the RAID item in BIOS
You must set the RAID item in the BIOS Setup before you can create a RAID set.
To do this:
1.
Install two internal SAS hard disk drives to the SAS connectors labeled
SAS1/2.
2.
Boot up your computer, and press <Del> during POST to enter the BIOS
setup.
3.
In the Advanced menu, go to Onboard Devices Configuration, and enable
both Marvell 6320/SAS and 6320 Boot ROM.
4.
Press <F10> to save the changes and exit.
Onboard Device Configuraiton
High Definition Audio
OnChip LAN1
OnChip LAN2
LAN Boot ROM
Marvell 6121/eSATA
6121 Boot ROM
Marvell 6320/SAS
6320 Boot ROM
Onboard 1394
Serial Port1 Address
The RAID BIOS setup screens shown in this section are for reference only, and
may not exactly match the items on your screen.
5-54
®
SAS RAID configurations
88SE6320 SAS controller allows you to configure RAID 0, RAID 1,
Advanced
[Enabled]
[Auto]
[Auto]
[Disabled]
[Legacy Mode]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[3F8/IRQ4]
v02.61 (C)Copyright 1985-2008, American Megatrends, Inc.
BIOS SETUP UTILITY
Enable or Disable
High Definition Audio
Controller
Select Screen
Select Item
+-
Change Option
F1
General Help
F10
Save and Exit
ESC
Exit
Chapter 5: Software support
Advertisement
Table of Contents
