Marker; Checking And Displaying Shooting Status; Pre Rec; Optical Image Stabilizer - Panasonic AG-HMC80PJ Operating Instructions Manual

Shooting techniques for different targets (continued)

Marker

If you press the ZEBRA button while zebra patterns
are displayed, a marker appears near the center
of the display (if you have set the setup menu,
SW&DISP SETUP, MARKER to ON).
The brightness of the areas near the screen center
can be checked as a percentage (0 % to 99 %).
"99%↑" appears if the percentage is over 99.
Image level detection area
99%
Image level
The normal display reappears if you press the
ZEBRA button again.
• The marker does not appear when the face
detection function is set to ON.
Checking and displaying shooting
status
DISP/MODE CHK button
If you press and hold the DISP/MODE CHK button
in recording standby mode or while recording, the
configuration status of all recording functions, a
list of USER button function assignments, focus
ring function, and all other camera information will
be displayed. Release the button to return to the
normal display.
Pressing the DISP/MODE CHK button during
recording or while recording is paused will
remove all displays from the screen except for the
operation status, counter, marker, and safety zone
display. Press the button again to return to the
normal display. (Page 99)
The display mode selected using the DISP/MODE
CHK button is retained even if you turn off the
camera by setting the POWER switch to OFF, or
change the operating mode.
60
Marker

PRE REC

Record video and audio from three seconds before
the time of the operation to begin recording.
Operation to start
recording
Actual recording
time
PRE REC time
1
Select ON for the PREREC MODE item in the
setting menu RECORD SETUP screen, and
then press the ENTER button.
PRE REC is displayed on the screen.
2
Press the START/STOP button.
Video and audio from approximately 3 seconds
previously will be recorded.
• Recording of the previous 3 seconds of video
and audio may not be possible if recording is
started immediately in the following cases.
� Immediately after switching from another
mode to CAMERA mode
� Immediately after turning power on
� Immediately after changing to PREREC
MODE item
• The thumbnail for clips recorded using the
PREREC function will display the image from
when the START/STOP button was pressed.

Optical Image Stabilizer

Use the Optical Image Stabilizer (OIS) to reduce
the effects of camera shake when shooting by
hand.
Press the OIS button to turn the function on and
off. The appears on the viewfinder when this
function is on. Turn the function off when using a
tripod for more natural images.
Operation to stop
recording
(Time)