Replacing Filter Bag - Hoover C1412 - Commercial Upright Vacuum Cleaner Operating Instructions Manual

Commercial upright vacuum cleaner
Hide thumbs Also See for C1412 - Commercial Upright Vacuum Cleaner:
Table of Contents

Advertisement

41
A
B
C
Select proper tool
A. Dusting brush may be used for
carved furniture, table tops, books,
lamps, lighting fixtures, venetian
blinds, baseboards, shutters, and
registers.
B. Furniture nozzle may be used
for upholstered furniture, draperies,
mattresses, clothing, automobile
interiors, and carpeted stairs.
C. Crevice tool may be used in tight
spaces, corners and along edges in
such places as dresser drawers,
upholstered furniture, stairs, and
baseboards.
D. Wand is used to give extra length
to your hose. Use it with any of the
above tools.
Maintenance
Disconnect cleaner from electrical
outlet before attempting to service
it in any manner.
Do not operate without paper bag
in place.
The filter bag
When to replace
Check filter bag from time to time. It
is recommended that you change
the filter bag when dirt reaches the
dotted line. If more dirt than this
accumulates, your cleaner may not
operate effectively.
Note: Check and change the filter
bag frequently when using cleaner
on new carpet due to rapid accumu-
lation of carpet fluff.
CAUTION: Very fine materials,
such as face powder, cornstarch,
fireplace ashes or fireplace soot,
may seal the filter bag and may
cause it to burst even though it is
only partially full of dirt. When
cleaner is used to remove material
of this nature, change filter bag
often.
42
D
Attach wand and tools
The tools are attached to the hose or
the wand in the same manner. Push
tool firmly onto hose; twist tool slight-
ly to tighten or loosen connection.
Use cleaning tools with cleaner han-
dle in upright position.
Where to buy
Filter bags may be purchased from
your local Authorized Hoover Dealer
(Depot), leading retailers, or from a
Hoover Factory Service Center.
What to buy
Use only Genuine HOOVER
gen Filtration Type A disposable fil-
ter bags in order to maintain the
original cleaning effectiveness of
your cleaner.
Regular HOOVER
able filter bags also fit your cleaner.
To assure that your cleaner operates
at peak performance, it is imperative
that you use only genuine HOOVER
filter bags made by The Hoover
Company. HOOVER bags can be
identified by these trademarks –
®
Aller-
®
Type A dispos-
®
43
E
Clearing blockages
To check for obstructions, first turn
cleaner off and disconnect from
electrical outlet; then disconnect
hose from cleaner. Open hose
door (E) and carefully remove any
visible obstruction. If no obstruction
is found, check hose and tools.
Remove obstruction. To continue
using tools, re-attach hose to clean-
er. If no obstruction is found and a
problem persists, contact your
Hoover Factory Service Center or
Authorized Warranty Service Dealer
(Depot).
How to clean tools
To clean the hose, wipe off dirt with
a cloth dampened in a liquid deter-
gent. Rinse with a damp cloth.
Cleaning tools may be washed in
warm water with a detergent. Rinse
and air dry before using.
44
A
How to replace
Disconnect cleaner from electrical
outlet.
To change filter bag, unzip outer bag,
grasp sides of filter bag collar (A) and
pull collar from tube.
Note: Do not clean out old filter bag
and reuse. Discard used filter bag.
Continued
9

Advertisement

Table of Contents
loading

Table of Contents