HP Model 748 - VME Workstation Manual page 4

Pci module

Hide thumbs Also See for Model 748 - VME Workstation:

Procedure

If you need keyboard and mouse support, you need a Hewlett-Packard P/S2

compatible keyboard and mouse to connect to the P/S2 connectors on the

VMEbus board computer.

Procedure

1 Stop any application programs, then shut down your workstation.

2 Turn the workstation off, and unplug the power cord(s).

WARNING:

To avoid electrical shock, make sure you unplug the power cable from the wall

outlet and the system unit before proceeding any further.

CAUTION:

The internal components of your workstation are susceptible to mechanical

and electrostatic shock. To prevent such damage from occurring, observe

the following precautions during the installation procedure.

3 Using a flat-tipped screwdriver, unscrew the captive screws inside the

4 Grasp the EISA module handles and pull the EISA module out of the

•

Stand on a static-free mat

• Wear a static-grounding wrist strap to ensure that any accumulated

electrostatic charge discharges from your body to ground. Attach the

static-grounding wrist strap by following the instructions on the pack-

age that contains the strap. Be sure to attach one end of the strap to the

system chassis.

• Handle workstation and upgrade kit components carefully to prevent

damage from mechanical shock.

EISA module handles five to seven turns (until each screw pops out).

chassis, as shown in Figure 1.

A4505a