HP Model 748 - VME Workstation Manual page 11

12 Plug in the power cord(s), and then turn on the power for the VMEbus
chassis and boot the operating system.
13 Log in as root and use the SAM utility to configure the HP-UX kernel for
PCI support.
14 When SAM has started, choose the Kernel Configuration ->
menu.
15 From the Kernel Configuration menu, choose Drivers
16 From the Drivers menu, select GSCtoPCI Driver.
17 Go to the Actions menu and select Create a New Kernel.
18 When the new kernel is built, SAM asks if you want to move the kernel
into place and reboot. Choose Yes.
The system reboots with the PCI driver loaded.
For More Information
Refer to Installing Peripherals and your PCI card's installation guide for
information on the PCI accessory card application, loading the software, and
running it.
Procedure
11