Ryobi JM82K Operator's Manual page 13

FENCE HEIGHT
The adjustable fence on the biscuit joiner can be moved
up or down to adjust the position of the blade in relation to
the top of the workpiece. A scale on each side of the fence
indicates the height of the fence from the center of the blade.
The fence can be positioned up to two inches from the center
of the blade. However, the scale and indicator point can only
be set up to 2 in. from the center of the blade. Scale marks
are in increments of 1/16 in.
SETTING THE FENCE HEIGHT
See Figure 7.
n Unplug the biscuit joiner.
n Loosen the locking knob approximately one turn.
n Move the fence up or down by rotating the height adjust-
ment knob until the indicator point is aligned with the
desired dimension on the scale.
n Tighten the locking knob securely.
FENCE ANGLE
The adjustable fence on the biscuit joiner can be set at angles
ranging from 0° to 135°, with accurate positive stops set
in 45° increments. A scale is located on each side of the
adjustable fence for identifying these positive stop angles.
Each stop reached when rotating the adjustable fence from
one angle setting to another equals a 45° positive stop angle
change.
SETTING THE FENCE ANGLE
See Figure 8.
n Unplug the biscuit joiner.
n Loosen the locking knob approximately one turn.
n Rotate the fence to the desired angle.
n Tighten the locking knob securely.
OPERATION
ADJUSTMENT
TO LOWER
TO RAISE
ADJUSTABLE
FENCE
13
HEIGHT SETTING
INDICATOR
SCALE
POINT
HEIGHT
KNOB
ANGLE SETTING
SCALE
ROTATE ADJUSTABLE FENCE
TO DESIRED ANGLE SETTING
TO
TIGHTEN
TO
LOOSEN
LOCKING
KNOB
Fig. 7
TO TIGHTEN
TO LOOSEN
Fig. 8