For Model 743 Only, Install New Boot Rom If Required - HP Model 744 - VME Workstation Installation And Service Manual

3. For Model 743 only, install new Boot ROM if required.

If after reading the prerequisites for firmware in Chapter 1 you must replace the Boot
ROM, use the following procedure.
a.
Remove the Boot ROM from its socket on the Model 743, at location U54, using the
IC removal tool as shown in Figure 2–3.
b.
Align the new Boot ROM in its socket, at location U54, with the keyed corner
matching the sockets keyed corner. Carefully press the new Boot ROM into its
socket. See Figure 2–3.
U54
Keyed Corner
Figure 2–3. Removing and Replacing the Boot ROM
Installing the FWD SCSI Adapter
2–5