e.
Loosen the SBC's two captive screws with a small flat blade screwdriver. Depending
on your configuration, you could have four captive screws – two on the SBC, and
two on the expansion slot. If you have these four captive screws, you will need to
remove all four. See Figure 2–1.
Captive Screws
Figure 2–1. Removing the Single Board Computer
f.
Push the ejector handles to the outside of the board and remove the SBC from the
card cage, as shown in Figure 2–1.
Installing the FWD SCSI Adapter
Captive Screws
2–3