Brother BE-1204B Instruction Manual page 242

Chapter 11 Error code list
Code
E-00 No error occurs.
Either motor of main shaft, X- or Y-axis, or
E-01
lower shaft has locked.
Overtravel occurs during home position
E-02
detecting movement.
The stop switch is pressed during home
E-03
position detecting movement.
E-04 Home position detection out of range
E-05 Needle stop position error
E-06 Needle bar case position error
E-07 Needle bar case lock
Stop switch or emergency switch was pressed
E-08
while the needle bar case is traveling.
E-09 X-axis home position detection error
E-0A Thread breaking error
E-0B Stop or emergency stop during sewing
E-0C Lower thread broke during embroidering.
The machine does not return to the home
E-0D
position.
E-0E Mending finish
E-0F Failed in the reading of needle bar No.
E-10 Abort by the beam sensor ON
E-11 Failed in the reading of X home position sensor
E-12 Failed in the reading of X home position sensor
11-2
Error
BE-1204B-BC • BE-1206B-BC
This is not usually displayed.
Press the or turn on the F/B switch on the head to either
side to restart the home position detecting movement again.
This is not usually displayed.
Adjust the pulley stop position (100 degrees) above the needle
and press the or turn on the F/B switch on the head to
either side.
Adjust the position of needle bar case manually, then press the
or turn ON the F/B switch on the head to either side. If the
same error occurs again, the color change proper position
sensor is faulty.
Press the or turn on the F/B switch on the head to either
side. If the same error occurs again, the color change
mechanism is faulty.
This is not usually displayed.
Turn the power off and on once. If the same error occurs
again, the X-axis mechanism is faulty.
After passing through the thread, press the
F/B switch on the head to either side.
This is not usually displayed.
After the replacement of the lower thread, press the
turn ON the F/B switch on the head to either side.
This is not usually displayed.
Press the or turn ON the F/B switch on the head to either
side. If the same error occurs again, the I/O CPU
communication is faulty, or the color change position sensor is
faulty.
Press the or turn ON the F/B switch on the head to either
side.
Press the or turn ON the F/B switch on the head to either
side. If the same error occurs again, the I/O CPU
communication is faulty.
Press the or turn ON the F/B switch on the head to either
side. If the same error occurs again, the I/O CPU
communication is faulty.
Measures
or turn on the
or