Dell PowerEdge 2800 Hardware Installation page 6

F6590bk0.book Page 4 Tuesday, July 6, 2004 4:33 PM
5
Slide the drive tray to the maintenance position.
Use a #2 Phillips screwdriver to loosen the captive screw that secures the drive tray
a
release handle to the chassis.
Rotate the drive tray release lever toward the front of the system.
b
Grasp both sides of the front panel and slide the drive tray towards the front of the
c
system until the tray is in the maintenance position.
Installing the Drive Cage
1
Locate the insert tab above the center filler plate. See Figure 1-1.
2
Press the insert tab and remove the center filler plate from the peripheral bay. See Figure 1-1.
NOTE:
Figure 1-1. Peripheral Bay Filler Plates
thumbscrew
cam handle
black square
lower filler plate
3
Locate the black square on the lower filler plate. See Figure 1-1.
4
Place your right thumb on the black square, reach behind the lower filler plate, squeeze
the lower filler plate release lever, and remove the filler plate from the peripheral bay.
1-4
Installing the 1 x 2 SCSI Module
If a tape drive is not installed in your system, do not remove the top filler plate.
center filler plate
top filler plate
insert tab