Panasonic WV-NF284E Installation Manual page 15

!9 INITIAL SET button
Use this button to reset the settings of
the camera to the default settings.
Turn off the power of the camera. Then,
turn on the power of the camera while
holding down this button and wait around
5 seconds without releasing this button.
Wait around 30 seconds after releasing
the button. The camera will restart and
the settings including the network and
the date/time settings will be initialized.
@0 Network connector
Connect a LAN cable (category 5) to this
connector. ( page 22)
@1 Safety wire holder
Attach the safety wire fixed with the cam-
era mount bracket to the holder. Make
sure that the safety wire is securely
hooked on the safety wire holder when
adjusting or installing the camera.
( page 18)
I Camera mount bracket
@2 Safety wire
Attach this wire to the safety wire holder
of the camera. Make sure that the safety
wire is securely hooked on the safety
wire holder when adjusting or installing
the camera. ( page 18)
15