Fujitsu fi-6130 Operator's Manual page 30

2.2 Loading Documents on the ADF for Scanning
4. Adjust the side guides to the width of the documents.
Move the side guides so that they touch both sides of the documents. If there is any space between the side guides and
the edges of documents, the scanned image may be skewed.
HINT
Use of the stacker or stacker extension prevents document sheets from dropping after they are
scanned.
Use the stacker and stacker extension as shown in the figure below.
file:////10.232.227.50/Manual/fi-6130_6230_Lynx3L/OG/R02/02_081030/contents/EN/02/c02_02_01.htm (3/4) [2008/10/30 15:13:46]
Material: PVC (Poly vinyl chloride) or PVCA (Polyvinyl chloride acetate)
Note: Before scanning your card, test with a dummy card of the same material to see
if it can be fed into the ADF properly.
Cards that are excessively rigid or less flexible may not feed smoothly and excessive
●
noise may occur.
Note: If the cards do not feed smoothly, try:
- Scanning one card at a time.
- Enabling [Automatic Paper Size Detection]. For how to configure this setting, see
Section "3.10 Correcting Skewed
- Raising the resolution.
Cards should be clean from oil and without labels.
●
Cards cannot be scanned when the imprinter is installed.
●
Documents."
Side guides