KitchenAid KSSC42QTS - 42" Refrigerator Installation Manual page 25

If the built-in area depth is 25" (63.5 cm) or more, the side panels
can be installed inside the side trim or attached to the outside of
the side trim.
IMPORTANT: KitchenAid is not responsible for the removal or
addition of molding or decorative panels that would not allow
access to the refrigerator for service.
1. For the inside side trim piece, slide the front edge of the
routed side panel into the trim piece.
2. Nail the rear edge of the panel to the support board.
B
A. Support board (mounted to back wall)
B. Cab side trim
3.
Snap the skirt onto the base grille.
4.
5.
_ L,IIIIL,,,,IIIIIII,,,,,IIIIIIIIII
A. Base grille
B. Skirt
Trim the skirt by scoring the proper "V" groove with a utility
knife. Break the skirt at the score line.
A
A. "V" groove
Using the two screws, attach the base grille assembly to the
refrigerator as shown.
NOTE: Drive in the right side screw first.
There are two pieces to the base grille to allow for a custom fit:
the base grille itself and the skirt. The skirt can be added to the
base grille in order to extend it all the way to the floor.
1. To see if the skirt is needed, place the base grille into
position. Do not attach the base grille to the refrigerator.
Measure the distance between the bottom of the base grille
and the floor. The gap must be a minimum of 1/2"(1.27 cm) in
order to add the skirt.
NOTE: If the gap measures less than 1/2"(1.27 cm), skip
steps 3 and 4 of the instructions, and install the base grille
only.
2. Remove the protective film from the base grille.
A
A. Screws (2)
25