Cleaning - Amana ARG7302 Series Owner's Manual

Cleaning

Part
Burner caps and
grates
Hard to clean burner
caps and grates
Burner base
Broiler Pan and Grid
Control knobs
Inside oven door
Outside finish and
backguard
Oven interior
surfaces
Oven racks and
storage drawer
Materials to Use
Soap and water
½ Cup ammonia
Soap and a non-
abrasive plastic
scouring pad, cloth,
toothbrush or straight
pin
Soap and a non-
abrasive plastic
scouring pad
Mild soap and water
Soap and water
Soap and water
Soap and water
Soap and water
General Directions
Cool before cleaning. Frequent cleaning with soap and water, and
non-abrasive pad prolongs time between deep cleanings. Be sure
to dry thoroughly.
Place burner caps and grates in plastic bag with ½ cup ammonia.
Do not pour ammonia into bag. Ammonia must remain in cup. To
avoid rust, do not soak grates in ammonia. Close bag tightly and
leave grate and caps overnight. Before bag is opened turn face
away to avoid breathing or eye contact with fumes. Remove
burner caps and grates from bag and rinse. Clean according to
instructions above.
Cool before cleaning. Clean burner base with warm soapy water
and a clean cloth. If ports in burner base are clogged, clean with
toothbrush or straight pin. Do not use toothpick. After cleaning
replace burner caps and turn on burners to check for proper
operation. See Operating Surface Burners section for burner
operating instructions.
Drain fat, cool pan and grid slightly. (Do not let soiled pan and
grid stand in oven to cool.) Sprinkle with soap. Fill the pan with
warm water. Let pan and grid stand for a few minutes. W ash or
scour if necessary. Rinse and dry. The broiler pan and grid may
also be cleaned in the dishwasher.
Pull off knobs. W ash gently but do not soak. Dry and return
controls to oven, making sure to match flat area on the knob to
the flat area on shaft.
Clean the outside of the door and the window area with warm
soapy water. Do not clean the oven door gasket. Gasket should
not be moved while cleaning. Avoid getting any cleaning materials
on gasket.
W ash all glass with cloth dampened in soapy water. Rinse and
polish with a dry cloth. If knobs are removed, do not allow water to
run down inside surface while cleaning.
Cool before cleaning. Frequent wiping with mild soap and water
prolongs time between self-cleanings. Be sure to rinse
thoroughly.
For heavy soil, clean by hand and rinse thoroughly. Remove the
drawer and racks for ease in cleaning. Be sure drawer is dry
before replacing.
26