Epson SureColor S50670 Setup Manual page 18

| Installing the Take-up Reel System
16
Connect the communication cord that is attached to the take-up reel system by running it through the
3.
horizontal struts to the back of the printer. Place the cable in the cable supports and plug it in, making
sure to tighten the screws on the plug to secure it in place.
Connect the power cords to the printer and use the cable supports to restrain the cords as shown.
4.
Plug the printer into outlets that are easily accessible. Note that two outlets are required, for a total of
5.
20 amps. It is recommended that the outlets be powered by a dedicated 30-amp circuit.