Lexmark C760 Service Manual page 70

5060-4xx
User primary
message
37 Insufficient
Memory
38 Memory Full
39 Complex Page
2-34
Service Manual
User secondary
Explanation
message
Held Jobs May Not This message displays when the printer has attempted to
Be Restored Print and Hold jobs from the disk and found that some or all
of the jobs could not be restored. Each of the three
Help Jobs May Not be
57 Configuration Held Jobs messages describe different
Restored
conditions under which the restore failed.
• Primary Message: 37 Insufficient Memory. The printer
• Primary Message: 57 Configuration Change - The
• Primary Message: Held Jobs May Not Be Restored
Note: Some of the Print and Hold jobs may not be restored.
They remain on the disk but cannot be accessed.
This message is displayed when the printer is processing an
incoming job and there is not enough memory available to
continue processing the job.
The following actions can be taken:
You may want to determine how to make more memory
available to your print job by:
• Deleting fonts, macros and other data in RAM
• Simplify your print job
• Install additional memory
• Press Go to clear the message, however some data may
• Press Menu to access the Busy/Waiting Menu
The following functions may be available.
• Cancel Job
• Reset Printer
• Reset Active Bin
• Check Supply Levels
Note: Menu Lockout does NOT prevent access to the Busy/
Waiting Menu.
This message is displayed when a page is too complex to
print.
The following actions can be taken:
• Press Go to clear the message and continue processing
• Try to simplify the print job
Press Menu to access the Busy/Waiting Menu.
The following functions may be available:
• Cancel Job
• Reset Printer
• Reset Active Bin
• Check Supply Levels
Note: Menu Lockout does NOT prevent access to the Busy/
Waiting Menu.
firmware ran out of memory while attempting to restore
the jobs.
Secondary Message: Held Jobs May Not Be Restored.
printer firmware could not restore jobs from the disk
because the configuration of the printer has changed.
Secondary Message: Held Jobs May Not Be Restored.
Some configuration changes that can cause a 57
Configuration Change message are:
- Code version change
- Paper handling option removed
- Disk drive has been moved to a different printer.
handles any other conditions where any of the Print and
Hold jobs could not be restored from the disk.
be lost
the job, some data loss may occur.