Handsfree Calling - Sony WX-GT90BT Operating Instructions Manual

Notes
• Some cellular phones require permission to
access their phonebook data during handsfree
connection to this unit. Obtain permission via
the cellular phone.
• While streaming Bluetooth audio, you cannot
connect from this unit to the cellular phone.
Connect from the cellular phone to this unit
instead. A connecting noise may be heard over
playback sound.
Tip
With Bluetooth signal on: when the ignition is
turned to on, this unit reconnects automatically
to the last-connected cellular phone. But
automatic connection also depends on the
cellular phone's specification. If automatic
connection is not made, connect manually.
Connecting an audio device
Press  and rotate the control
1
dial until "BT SIGNL" appears, then
press it.
" " lights up when Bluetooth signal is
activated.
2
Turn on the audio device and activate
the Bluetooth signal.
3
Connect to this unit using the audio
device.
" " appears when the connection is
made.
Connecting the last-connected audio
device from this unit
1
Make sure the Bluetooth signal of the audio
device is activated.
Press  repeatedly until "BT
2
AUDIO" appears.
Press  (PAUSE).
3
" " flashes while the connection is
being made, then stays lit while
connected.

Handsfree calling

Once the unit is connected to the cellular
phone, you can make/receive handsfree
calls by operating this unit.
Before handsfree calling, check the
following:
 Make sure that " " and " " appear in
the display.
 If " " and " " do not appear, perform
the connection procedure (page 22).
 If you cannot connect this unit and the
cellular phone via the Bluetooth
function, perform the pairing procedure
(page 21).
Receiving calls
When receiving a call, a ringtone is output
from your car speakers or the connected
cellular phone. The caller's name or phone
number appears in the display.
1 Press  when a call is received
with a ringtone.
The phone call starts.
23