Wi-Fi [HC-V520]/[HC-V520M]
Connecting to Wi-Fi
To use the Wi-Fi function, connect this unit to a wireless access point or smartphone via Wi-Fi.
If the clock has been set for the first time, the confirmation message for the Wi-Fi settings will be
displayed. Touch [YES], and then configure the access point settings below.
∫ About the status indicator and the connection status icon when
connected to Wi-Fi
Connecting to a wireless access point
Check if the wireless access point you are using is compatible with WPS
j If the wireless access point is compatible with WPS:
Proceed to the following [Easy Connection (WPS)]
j If the wireless access point is not compatible with WPS:
[Manual Connection]
≥ WPS is an abbreviation for Wi-Fi Protected Setup™
[Easy Connection (WPS)]
∫ If this is the first time the Wi-Fi button is pressed
1
Press Wi-Fi button.
2
Touch [YES].
3
Touch [Easy Connection (WPS)].
4
Set the wireless access point to waiting for WPS.
≥ For further details, please read the operating instructions for the
wireless access point.
≥ A message is displayed when the connection is complete.
≥ A message is displayed when the connection attempt fails. Touch
[EXIT], and set the connection again.
A Lit green
≥ The status indicator is lit green while this unit is connected
to a destination device after completing a Wi-Fi connection.
≥ When Wi-Fi is disconnected, the status indicator is lit
red again.
B The connection status icon
When connected to wireless access point:
connected to Wi-Fi/
≥ The display will change as follows according to the
radio wave intensity:
When directly connected:
connected to Wi-Fi/
(l
128)
- 126 -
not connected to Wi-Fi
#
#
#
not connected to Wi-Fi
.