Beep Codes; Pei Beep Codes; Dxe Beep Codes; Undetermined Problems - Acer Veriton N2110G Service Manual

Beep Codes

When no error message is displayed but the computer stops during POST, listen for beep codes.

PEI Beep Codes

No. of Beeps
4
5
5
1
6
7

DXE Beep Codes

No. of Beeps
4
5
5
1
6
7

Undetermined Problems

NOTE • Verify that all attached devices are supported by the computer.
• Verify that the power supply being used at the time of the failure is operating correctly. (See
"Power System Check" on page 37)
Follow the procedures below to isolate the failing FRU. Do not isolate non-defective FRU.
1. Power off the computer.
2. Visually check them for damage. If any problems are found, replace the FRU.
3. Remove or disconnect all of the following devices:
• Non-Acer devices
• SSD drive
• DIMM
4. Power on the computer.
5. Determine if the problem has been resolved.
6. If the problem does not recur, reconnect the removed devices one at a time until you find the failed FRU.
If the problem persists, replace the mainboard. Do not replace a non-defective FRU.
46
Description
Some of the Architectural Protocols are not available
No Console Output Devices are found
No Console Input Devices are found
Invalid password
Flash update is failed
Reset protocol is not available
Description
Some of the Architectural Protocols are not available
No Console Output Devices are found
No Console Input Devices are found
Invalid password
Flash update is failed
Reset protocol is not available
Veriton N2110G Service Guide