Table of Contents
Advertisement
1.6
Before you proceed
Take note of the following precautions before you install motherboard components
or change any motherboard settings.
1. Unplug the power cord from the wall socket before touching any
2. Use a grounded wrist strap or touch a safely grounded object or to a metal
3. Hold components by the edges to avoid touching the ICs on them.
4. Whenever you uninstall any component, place it on a grounded antistatic
5. Before you install or remove any component, ensure that the ATX
When lit, the standby power LED (SB_PWR1) indicates that the system is ON,
in sleep mode, or in soft-off mode, a reminder that you should shut down the
system and unplug the power cable before removing or plugging in any
motherboard component.
P4P8X SE Onboard LED
1-10
component.
object, such as the power supply case, before handling components to
avoid damaging them due to static electricity.
pad or in the bag that came with the component.
power supply is switched off or the power cord is detached from the
power supply. Failure to do so may cause severe damage to the
motherboard, peripherals, and/or components.
®
P4P8X SE
SB_PWR1
ON
OFF
Standby
Powered
Power
Off
Chapter 1: Product introduction
Advertisement
Table of Contents
