Appendix; Troubleshooting - AgfaPhoto DC-630 User Manual

Appendix

Troubleshooting

Problem
Power does not turn on.
The camera does not take
pictures.
Image is not recorded when
the shutter button is
pressed.
The flash does not fire
Image is blurry or out of
focus.
Image is not displayed on the
LCD monitor.
Recorded images are not
saved in memory.
Cannot transfer images to a
computer after connecting
the USB cable.
Cause
Battery is inserted in the
wrong direction.
Batteries are dead.
The battery compartment
door is open.
The flash is charging.
Memory is full.
Memory card is not
formatted correctly.
The Flash is charge.
Memory is full.
Flash is set to OFF.
The camera was moving
when the image was
captured.
The subject was beyond
the range within which the
camera can focus.
A memory card with
non-DCIF images (recorded
with other camera) is
loaded.
The camera was turned
off/powered down before
the image was stored in
memory
USB driver is not installed.
- 49 -
Solution
Reload battery in the correct
direction.
Replace or recharge batteries.
Make sure the battery compartment
door is securely closed.
Wait for the flash to charge.
Insert a new memory card.
The card may be detective, use a new
card.
Wait for the flash to charge.
Insert a new memory card.
Set the flash to any mode except off.
Hold the camera steady when
shooting picture.
Turn the Macro mode on it the subject
is within 5 cm (zoom out) or 25 cm
(zoom in).
Do not use Macro mode when
shooting distant subjects.
This camera cannot display non-DCIF
images.
If the battery low indicator appears
on the LCD monitor, replace the
battery immediately.
Install the USB driver before you
connect the camera to a computer /
turn the camera on.