Phone IP address
●
address of your device.
DNS address
— Enter the IP addresses of the
●
primary and secondary DNS servers, if required by
your service provider. Contact your internet service
provider to obtain these addresses.
Proxy server address
●
proxy server.
Proxy port number
●
the proxy server.
WLAN internet access points
Press
, and select
Connection
Access points
>
New access
point.
Follow the instructions from the WLAN service
provider.
WLAN network name
●
Search for
networks. If you select an existing
network,
WLAN network mode
security mode
access point device.
Network status
●
name is displayed.
WLAN network mode
●
an ad hoc network and to allow devices to send and
receive data directly; a WLAN access point device is
not needed. In an ad hoc network, all devices must
142
use the same
WLAN network
(for IPV4 only) — Enter the IP
— Enter the address of the
— Enter the port number of
Tools
Settings
>
>
Options
>
— Select
Enter manually
and
WLAN
are determined by the settings of its
— Define whether the network
— Select
Ad-hoc
name.
WLAN security mode
●
used: WEP,
WPA/WPA2. If you select
encryption is used. The WEP, 802.1x, and WPA
functions can be used only if the network supports
them.
To enter the settings for the selected security mode,
select
WLAN security
Security settings for WEP
WEP key in use
●
privacy (WEP) key number. You can create up to four
WEP keys. The same settings must be entered on the
Edit
or
WLAN access point device.
>
Authentication type
●
the authentication type between your device and
the WLAN access point device.
WEP key settings
●
or
of the key),
Hexadecimal), and
the selected format).
Security settings for 802.1x and WPA/WPA2
WPA/WPA2
●
EAP
to use an extensible authentication protocol
to create
(EAP) plug-in, or
Complete the appropriate settings:
EAP plug-in settings
●
your service provider instructs.
— Select the encryption
802.1x
(not for ad hoc networks), or
Open
network, no
settings.
— Select the wired equivalent
— Select
Open
— Enter
WEP encryption
WEP key format (ASCII
WEP key
(the WEP key data in
— Select the means of authentication:
Pre-shared key
to use a password.
— Enter the settings as
or
Shared
for
(length
or