System Setup; Setup Mode; Setup Screen (First); Brightness - Acura 2009 MDX Navigation System Navigation Manual

Setup Mode

The Setup function consists of two main
screens that allow you to change and
update information in the system. To
display the Setup screen (first), use the
voice control system and say "Setup" or
press the SETUP button. To change to
the Setup screen (second), say or select
MORE in the upper right corner of the
screen.
You can use the voice control system to
select any item on the Setup screen.
NOTE:
• If some items appear to be grayed out
and cannot be selected, it is because
you did not select OK on the initial
Disclaimer screen. See System Start-
up on page 17.
• Setup items in this manual with the
symbol indicate that the
display settings depend on what
"Driver #" was displayed on the MID
when the vehicle was started. See
Remote Keyless Entry Setting on
page 18.
• If only "Welcome" is displayed, then
all Setup settings revert to factory
defaults, and all personal data (such
as Address Book or Calendar) are not
available.
• For information on the available
voice commands, see Voice
Command Index on page 164.

System Setup

Setup Screen (first)

From any screen, say "Setup screen" or
press the SETUP button, and the
following screen appears:

Brightness

The screen brightness has 11 settings.
To change the brightness, use the voice
control system and say "Brightness up"
or "Brightness down." You can also
select Brightness and change the
setting by rotating the Interface Dial
knob.
Tip:
If you are having trouble viewing the
screen in bright lighting conditions, try
increasing the brightness.
Navigation System
83