4.5.9
Removing the Touchpad
The touchpad is connected to the top cover.
assembly:
1.
Peel off the mylar.
2.
Remove the three screws and disconnect the touchpad cable (J2), then remove the touchpad
main sensor and connector unit.
3.
Lift up and remove the touchpad.
4. Lift up and remove the touchpad buttons.
Touchpad mylar
Touchpad cable
Touchpad knob
Touchpad and circuit
Figure 4-26
Removing the Touchpad
Disassembly and Unit Replacement
Follow these steps to remove the touchpad
Screw list:
¶ ¶ x 3, M2L4
4-21