Dell 5110cn - Color Laser Printer User Manual page 53

To specify the Security Architecture settings for Internet Protocol (IPsec) for encrypted communication to the
printer.
Values:
Protocol
IKE
Pre-Shared Key
Re-enter Pre-Shared Key
IKE SA Lifetime
IPsec SA Lifetime
DH Group
PFS
Remote peers IPv4 address
Remote peers IPv6 address
Non IPsec communication
policy
NOTE: If IPsec is enabled with incorrect settings, you must disable it using the Reset IPsec menu on
the operator panel.
Reset Print Server
Purpose:
To initialize NVRAM for the network feature and reboot the printer.
Initialize the printer's NVRAM from the Initialize NVM in the Printer Settings.
Values:
Initialize NIC NVRAM
Memory and restart printer
Restart Printer
Print Volume
Select the check box to enable the protocol.
Use a preshared key for IKE authentication.
Specifies a shared key.
Enter the shared key again to confirm it.
Sets the lifetime for IKE SA from 5 to 28800 minutes.
Sets the lifetime for IPsec SA from 5 to 2880 minutes.
Selects the DH group.
Selects the check box to enable the PFS setting.
Specifies the IP address to connect to.
Specifies the IP address to connect to.
Selects whether or not to communicate with a device which does not
support IPsec.
Click the Start button to initialize NVRAM. Network settings will revert to
the factory default settings and reboot the network capability.
Click the Start button to reboot printer.