Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
1. Carefully unpack and remove your unit from the box.
2. Make sure all the items have been included:
Base Unit
Handset Unit
Rechargeable Ni-Cd Battery Pack
3.
Make sure the Rechargeable Battery is installed or install the Rechargeable
Battery as described on the next page.
PLEASE REFER TO THE FOLLOWING DIAGRAM FOR STEPS 4 THROUGH 7:
4. Slide the T/P switch on the bottom of the Base unit to TONE or PULSE to
match the service provided on your telephone line. If you are not sure of
your service, please contact your telephone company. The factory preset
position for this switch is TONE.
AC POWER
ADAPTER
5. Connect the telephone line cord into a modular telephone jack.
6. Insert the small plug at the end of the AC adapter into the DC power jack
located at the rear of the base.
NOTE: Use only the AC adapter provided with your unit.
7. Plug the AC adapter into a standard 120V AC wall outlet.
AC Adapter
Telephone Cord
Belt Clip
7
8
TELEPHONE
LINE CORD
12/16/01, 12:29 PM
Advertisement
Table of Contents
