Maxtor QUICKVIEW 300 Product Manual page 54

ATA Bus Interface and ATA Commands
Word
85 7:
6:
5:
4:
3:
2:
1:
0:
86 Command set/feature enabled.
15-14:
13:
12:
11:
10:
9:
8:
7:
6:
5:
4:
3:
2:
1:
0:
87 Command set/feature default.
15:
14:
13-8:
7:
5-12 Quickview 300 80/100/120/160/200/250/300GB PATA
Table 5-2
Identify Drive Command Parameters
CONTENT DESCRIPTION
1 = release interrupt enabled
1 = look-ahead enabled
1 = write cache enabled
Shall be cleared to zero to indicate that the PACKET Command feature set is
not supported.
1 = Power Management feature set enabled
1 = Removable Media feature set enabled
1 = Security Mode feature set enabled
1 = SMART feature set enabled
Reserved
1 = FLUSH CACHE EXT command supported
1 = FLUSH CACHE command supported
1 = Device Configuration Overlay supported
1 = 48-bit Address features set supported
1 = Automatic Acoustic Management feature set enabled
1 = SET MAX security extension enabled by SET MAX SET PASSWORD
See Address Offset Reserved Area Boot, INCITS TR27:2001
1 = SET FEATURES subcommand required to spin-up after power-up
1 = Power-Up In Standby feature set enabled
1 = Removable Media Status Notification feature set enabled
1 = Advanced Power Management feature set enabled
1 = CFA feature set enabled
1 = READ/WRITE DMA QUEUED command supported
1 = DOWNLOAD MICROCODE command supported
Shall be cleared to zero
Shall be set to one
Reserved
1 = WRITE DMA QUEUED FUA EXT command supported