Features - Haier HLT10 Instruction Manual

PRECAUTIONS
--TO PROLONG USE TIME, PLEASE MAKE SURE THE INTERVAL OF
SWITCHING ON AND OFF IS NOT LESS THAN 5 SECONDS.
--PROTECT THE POWER CORD FROM BEING WALKED ON OR PINCHED,
PARTICULARLY AT PLUGS, CONVENIENCE RECEPTACLES, AND THE POINT
WHERE THEY EXIT THE PRODUCT.
USING OF POWER：
-- DO NOT CONNECT TO POWER OVER PRESCRIPTIVE VOLTAGE, USE THE
CORRECT VOLTAGE AND CURRENT MARKED ON THE PRODUCT ELECTRICAL
RATINGS LABEL. ELECTRIC POWER OVERLOAD WILL CAUSE FIRE OR ELECTRIC
SHOCK.
-- DO NOT PULL CABLES ,SHOULD HOLD PLUG WHEN USING POWER SOCKET.
-- UNPLUG AC CABLE FROM POWER SOCKET IF NOT USE THE UNIT FOR LONG
TIME.
BATTERY USAGE AND HANDING:
--KEEP BATTERY AWAY FROM CHILDREN AND PETS.
--REMOVE THE BATTERY FROM THE REMOTE CONTROL WHEN THE PRODUCT
WILL NOT BE USED FOR AN EXTENDED PERIOD.
--NEVER THROW BATTERY INTO A FIRE. DO NOT EXPOSE BATTERY TO FIRE OR
OTHER HEAT SOURCES.

FEATURES

10.2"TFT DISPLAY
Built in ATSC/NTSC Tuner.
AUTO TV SCANNING FUNCTION
MEMORY FUNCTION
SUPPORT VIDEO/AUDIO INPUT
DIGITAL BROADCASTING RECEPTION
2
GENERAL TROUBLESHOOTING
Check the following points before assuming malfunctions of the TV set:
Problem
No picture & sound Improper connection of AC adaptor or the battery power
No picture Reception may not be adequate. Relate the unit or change the antenna
direction.
No sound Volume is too low; Mute function is switched on.
The headphone has been plugged in or the signal is too weak .
Poor reception TV antenna is not correctly adjusted or TV channel is not right.
Dark or blurred picture The bright & contrast is too low. The battery voltage is too low.
Unclear or unstable TV antenna is not properly adjusted or in too weak signal
picture reception area.
Picture moves up & TV antenna is not rightly adjusted.
down,blurs or folds The signal reception is too weak or caused by signal reflection
over from the buildings nearby or mountains.
Interfered snow The signal is interfered by car,s engine, railway, high tension
picture wires, neon signs or radio frequency.
No color Color or color system is not set properly.
MAINTENANCE
• Be sure to press POWER to set the player to the standby mode and disconnect
the AC adaptor before maintaining the player.
• Wipe the player with a dry, soft cloth.
• If the surfaces are extremely dirty ,wipe clean with a cloth which has been
dipped in a weak soap-and-water solution and wrung out thoroughly, and then
wipe again with a dry cloth.
• Never use alcohol, benzine, thinner, cleaning fluid or other chemicals. And do
not use compressed air to remove dust.
Reasons
is low.
23