Install Battery - Haier HLT10 Instruction Manual

2. AUDIO SETUP
Press left or right button to enter audio setup page:
Sound mode
-press up or down button to select it and then press left or right button to set the sound mode
as Personal, Standard, Music or Movie.
Bass/Treble/Balance
-press up or down button to select Bass/Treble/Balance and then press left or right button to
adjust.
-The Bass/Treble/Balance can be adjusted from 0-100.
Audio Language
Audio Channel
-To switch the Audio channel: L+L/ L+R/ R+R
3. TIME SETIUP
Press left or right button to enter time setup page:
16

INSTALL BATTERY

INSTALL THE BATTERY AS FOLLOWS:
1. Unscrew the screw to remove battery cover.
2.Put the lithium battery in the flute.
3.Close the cover, then tighten the screw.
Note:
-Before install the battery, please push the POWER ON/OFF switch to OFF.
-Twist off or tighten the screw only on the sense showed by the direction on the unit.
-When closing the cover, you should aim at the slot accuracy.
Rechargeable Battery Use
1.Charge the battery
-Slow charge: The battery will charge in the play mode at a slow pace takes up to 12 hrs to charge
completely.
-Rapid charge: Connect the AC adapter to unit and trun the power switch off, the battery will charge at
rapid pace in 3 hrs.
- The indicator is red during charging; it gets green when charging completed.
2.Using and Maintaining Rechargeable Battery
-.The normal working condition temperature is: 0 ~45 ;
-.Always unplug AC/DC power supply for the unit whenever not playing.
NOTE:
A new battery pack which has not been used or one which has not been used for
more than a month, may appear to not recharged enough , this is due to the characteristic
of this battery and is not a malfunction. In this case, recharge it two or three times before
the first use，and it needs more than 8 hours to recharge battery.
Noises may be generated during recharging. In this case, use a more distant power socket.
Do not recharge or discharge battery near a heating element such as a heater or direct
sunlight.
9