Upgrading The Firmware - HP LC2000r - NetServer - 128 MB RAM Installation Manual

Chapter 7
Table 7-1. Configuration Switches – CPU Speed
Speed Switch 1
550 MHz ON
600 MHz OFF
650 MHz OFF
700 MHz OFF
750 MHz OFF
Table 7-2. Configuration Switches S5-S8
Switch
Switch 5
Switch 6
Switch 7
Switch 8
NOTE
Some processor speeds listed in Table 7-1 may not be
supported. For the latest support information, visit the HP web
site:

Upgrading the Firmware

Load the HP NetServer Navigator CD-ROM and then power on the LH 6000r and
LH 6000. Follow instructions to ensure that the BIOS is up-to-date.
NOTE You are not required to use the HP NetServer Navigator
CD-ROM to reconfigure your system after installing the new
processor. The NetServer detects the additional processors
automatically. However, HP recommends using the HP
NetServer Navigator CD-ROM that comes with the processor
upgrade kit to ensure you have the latest drivers and
information.
Switch 2
OFF
ON
ON
ON
ON
Function
Clear Configuration
Clear Password
Boot Block
Not Used
http://www.hp.com/go/netserver
Installing Additional Processors
Switch 3 Switch 4
OFF OFF
ON ON
ON OFF
OFF ON
OFF OFF
To Enable
ON (normally OFF)
ON (normally OFF)
ON (normally OFF)
N/A (normally OFF)
77