Hp Netserver Navigator Cd-Rom - HP LC2000r - NetServer - 128 MB RAM Installation Manual

Chapter 10
Enable LVD SCSI indicates that LVD SCSI is enabled and
HP NetRAID is disabled. This is the correct setting for non-RAID
operation of the mass storage cages connected to SCSI A and B on the
I/O board.
Enable HP NetRAID indicates that HP NetRAID is enabled to
provide RAID operation of the mass storage cages connected to
SCSI A and B on the I/O board. This is the default value.
CAUTION
If your HP NetServer was previously operating in non-RAID
mode (Enable LVD SCSI), changing to RAID mode (Enable
HP NetRAID) could cause data loss. Be sure your data is
backed up before you change to RAID mode.
If your HP NetServer was previously operating in RAID mode
(Enable HP NetRAID), changing to non-RAID mode (Enable
LVD SCSI) could cause data loss. Be sure your data is backed
up before you change to non-RAID mode.
If the value is not Enable LVD SCSI, use the +/- keys to change it to
Enable LVD SCSI. This change will take effect when the HP NetServer
restarts.
Exit Setup Utility
12. Press the F10 function key to save and exit.
13. In the Setup Confirmation dialog box, press Enter to answer "Yes" to the
question, "Save configuration changes and exit now?" The HP NetServer
will restart.

HP NetServer Navigator CD-ROM

Use the HP NetServer Navigator CD-ROM (Navigator) to perform configuration
tasks or view online system documentation. There are two ways to do this.
Server Mode - You autorun the Navigator CD-ROM on your NetServer to
perform the configuration tasks. Server Mode is the mode you use to initially
setup and configure your HP NetServer. Using this mode you can set the system
language, time, date, and set resources for installed accessories and run utility and
troubleshooting software.
Resource Mode - The Resource Mode of operation allows any user to 'autoplay'
the Navigator CD in any Windows 95/98 or NT client. This mode provides access
104
Configuring the HP NetServer