Getting Started; Safety Warnings; Electrostatic Discharge (Esd) Precautions - HP j6700 - Workstation Upgrade Instructions

1

Getting Started

The following important information must be adhered to for proper removal and
replacement of all Hewlett-Packard parts.
CAUTION This upgrade process should be performed by experienced hardware users
only.

Safety Warnings

WARNING Removing the device cover may expose sharp edges in the equipment
chassis. To avoid injury, use care when installing customer add-on
devices.
NOTE Before performing removal/replacement procedures, position the workstation
on a cushioned flat, stable surface, such as a table top or workbench.
NOTE Installing the recommended HP replacement part in your J6700 workstation
does not affect the regulatory and safety classifications or approvals listed in
the original owner's guide.

Electrostatic Discharge (ESD) Precautions

To prevent damage to the J6700 workstation, observe all of the following ESD precautions
while performing removal and replacement procedures:
• Remove all ESD-generating materials from the work area in which you will remove and
replace the workstation field replaceable unit(s).
• Open the ESD materials provided with the replacement part kit. Unfold the black
conductive sheeting (antistatic mat) and place it under a corner of the workstation.
• Wear a static strap to ensure that any accumulated electrostatic charge is discharged
from your body to ground. Attach the static-grounding wrist strap by following the
instructions on the package. Attach the sticky end of the wrist strap to bare metal on
the rear panel of the workstation.
• Connect all equipment together, including the static-free mat, static strap, clips
attached to the wrist strap, and peripheral units.
3